I'm Back!

Here it is, the middle of September already.  Hard to believe.  Well, shortly after my last post (back on August 5th), I decided it was time to take a short break from the car and pay more attention to the rest of my life (like family, friends, vacations, etc.).  What a great month I had!  A family vacation in Colorado filled with white water rafting, hot air ballooning, mountain biking and hiking.  Wonderful visits from friends near and far.  More trips to Vermont and California.  A hurricane.  And last but not least, the start of school.

This week, I finally got myself back in the garage.  Surprisingly, it was harder than I thought to get back into it.  I went out there Monday and started surveying where I had left off.  There were bolts left on the bench to remind me they had to go back on the car, but now I can't remember where.  There were things to do everywhere I looked.  Where did I leave off?  Where should I get started?

I decided to start with something quick and simple to feel like I accomplished something.  For that, I made and installed a short piece of brake line that I had measured before the break.  It felt good to get something done and that got me going again.  Laurie can tell that I'm back to work because I've already gotten three parts deliveries this week!

I found some old to-do lists and started tackling them.  Here are a few pictures:

This is a shot showing the firewall (the curved black piece behind the engine.  The one thing I did do during my break was to pick-up all the aluminum panels that had been powder coated.  They turned out great!

I test fit the dashboard to see how much room I have for a heater.  I got a little sidetracked by this because I thought I'd have to drill holes in the firewall for the heater (and I will at some point), but I decided to put the heater aside for awhile.  Hopefully, I won't regret putting this off.

I finished the connections for the hydraulic clutch so now it's ready to be filled with fluid and tested.

Here is another aluminum panel that forms the front wall of the driver's side compartment.  The brake master cylinder went in today (the white plastic unit).

I also completed a few other odds and ends:
     - Made a shim to raise the transmission for better alignment with the rear end and to help change the engine angle.
     - Made a magnetic switch to sense when the brake fluid level is too low.  This will be required to pass NJ inspection.
     - Started applying a soundproofing material to the aluminum panels so the car doesn't sound like a tin can.
     - Figured out how to permanently wire the battery and starter (and ordered the parts).

As I've said before, my next goal is to get the car moving under its own power.  I still have to run two more brake lines, bleed the brakes and the clutch, reattach the steering, connect the fuel lines and throttle, and permanently mount the radiator.  I keep telling myself that I'm close.  Maybe about 3 more weeks.

All in all, a good week.